Settings On The Océ Tds700 Scanner Operator Panel - Oce TDS700 User Manual

Settings on the Océ TDS700 scanner operator panel
Introduction
When the scanner templates are enabled in the Océ TDS700 Power Logic
controller application the templates are displayed on start-up of the Océ TDS700
flexible scanner. When the templates are not enabled in the Océ TDS700 Power
®
Logic controller application, the 'Custom' card is displayed on start-up.
The Custom card gives access to the settings you defined in the Océ TDS700 Power
®
Logic controller application. This card contains a number of settings which are
immediately accessible. The key operator defines the Custom card in the Océ
TDS700 Power Logic
How to make settings on the scanner operator panel
Select a template (only applies when scanner templates on the scanner operator
1.
panel are enabled in the Océ TDS700 Power Logic
Press one of the Section keys to activate the desired menu.
2.
Note: The active menu is slightly moved downwards to visually separate it from the
other menus. Apart from that, a shadow highlighting effect is used for extra
highlighting.
Press the Card selection key to select the appropriate card. You can switch cards
3.
(from bottom to top) by pressing the key again.
Select the desired function values in one of the following ways.
4.
Simple (non-numeric) selection: Press the Function key to activate the desired
(non-numeric) value. The selected value is preceded by a bullet.
Long list selection: If you want to select a value from a list of options that cannot be
fully displayed on the panel, you first activate the selection triangles next to the
specified option (the dotted line around this selection is changed into an
uninterrupted line and the selection triangles are no longer dimmed). The triangles
indicate that there are additional options available. Select one of the non-displayed
values with the arrow keys.
Numeric selection: Activate the selection triangles and select the desired value with
the arrow keys or with the numeric keys.
Note: A combination of simple selection and numeric selection is possible as well.
Settings on the Océ TDS700 scanner operator panel
®
controller application.
®
controller application).
®
177