Specifications; Safety Instructions; Electrical Safeguards; General Safeguards - GBC HeatSeal H215 HighSpeed Insrtruction Manual

Specifications

Electrical
Machine Dimensions
Machine Weight
Maximum Pouch Width
Maximum Pouch Thickness
Maximum Thru-put Thickness
Warm-Up Time (2 x 75 mic)

Safety instructions

YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT
TO ACCO BRANDS EUROPE. IN THIS INSTRUCTION MANUAL AND ON
THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE
MESSAGES CAREFULLY.
m
THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY
MESSAGE IN THIS INSTRUCTION MANUAL.
THIS SYMBOL INDICATES A POTENTIAL PERSONAL
SAFETY HAZARD THAT COULD HURT YOU OR OTHERS,
AS WELL AS CAUSE PRODUCT DAMAGE OR PROPERTY
DAMAGE.
THIS WARNING IS FOUND ON THE PRODUCT.
c
m
Electrical shock hazard.
Do not open. No user
servicable parts inside.
Refer servicing to qualified
service personnel.
This safety message means that you could be seriously hurt or killed if
you open the product and expose yourself to hazardous voltage.
The following ISO and IEC symbols appear on this product, and their
meanings are as follows:
On / Off
Release
Special notice
Thank you, for your recent purchase of a GBC Pouch Laminator. Your
new laminator may emit a slight odour during the initial stage of
operation. It is normal and will diminish after several hours of operation.
Cleaning
m
Caution: Unplug this product before cleaning.
• Wipe exterior only with a damp cloth. Do not use detergents
or solvents.
• Do not use aerosol dusters or cleaners.
• Do not spray anything into the machine.
4
GBC HeatSeal H215 HighSpeed
230V / 50Hz / 1.7 Amps / 380W
455 x 172 x 131 mm
2.2 kg
245mm
2 x 125 mic (Total 250)
0.6mm
5 minutes
WARNING
Heat
GBC HeatSeal H315 HighSpeed
230V / 50Hz / 1.7 Amps / 380W
566 x 198 x 138 mm
3.00 kg
320mm
2 x 125 mic (Total 250)
0.6mm
5 minutes
m
Important safeguards
m
WARNING: FOR YOUR PROTECTION DO NOT CONNECT
THE POUCH LAMINATOR TO ELECTRICAL POWER UNTIL
YOU READ THESE INSTRUCTIONS COMPLETELY. KEEP
THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR
FUTURE REFERENCE. TO GUARD AGAINST INJURY, THE
FOLLOWING BASIC SAFETY PRECAUTIONS MUST BE
OBSERVED IN THE SET-UP AND USE OF THIS PRODUCT.

General safeguards

• Use the unit only for its intended purposes of laminating documents.
• Do not place anything in the throat opening of the laminator other than
pouches/documents.
• Place unit on a secure, stable work area to prevent the unit from
falling and possibly causing personal injury and damage to the unit.
• Follow all warnings and instructions marked on the unit.
• The socket outlet shall be installed near the equipment and shall be
easily accessible.
• Do not attempt single side lamination, this will destroy the laminator.
• Do not block the vent slots, this will cause the laminator to overheat.

Electrical safeguards

• The unit must be connected to a supply voltage corresponding to the
electrical rating shown on the unit.
• Unplug the unit before moving it, or when it is not in use for an
extended period of time.
• Do not operate with a damaged supply cord or plug. Do not alter the
attachment plug. The plug is configured for the appropriate electrical
supply.
• Do not overload electrical outlets beyond their capacity; fire or
electrical shock could result.
• The unit is intended for indoor use only.
• Never push objects through the cabinet slots. Do not spill liquid of any
kind on this product.
• Close supervision is required when this product is used near children.
m