Assembly - Weslo Cadence 720 User Manual

ASSEMBLY

Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• As you assemble the treadmill, be sure that all
parts are oriented as shown in the drawings.
• Note: The underside of the treadmill walking belt
is coated with high-performance lubricant. During
shipping, a small amount of lubricant may be
transferred to the top of the walking belt or the
1. Refer to drawing 2 below. Note that the Console
(49) is connected to the right Upright (37) by the
Wire Harness (53). During assembly steps 1–3,
be careful to avoid damaging the Wire Harness.
With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(55) on the base of the Uprights (37) as shown.
Make sure that the Base Leg Pads (31) and the
Wheel (34) are in the indicated positions. Attach the
Base Leg with two of the four Base Leg Bolts (28),
Base Leg Washers (68), and Base Leg Nuts (61).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (55) as described.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base Legs
(55) are resting flat on the floor.
2. Hold the treadmill firmly with both hands, and lower
the treadmill to the floor. To decrease the possibili-
ty of injury, bend your legs and keep your back
straight.
shipping carton. This is a normal condition and
does not affect treadmill performance. If there is
lubricant on top of the walking belt, wipe off the
lubricant with a soft cloth and a mild, non-
abrasive cleaner.
The following tools (not included) are required
for assembly:
• Two (2) adjustable spanners
• One (1) phillips screwdriver
If further assistance is needed, please call our
Customer Service Department at 0345-089009.
1
37
61
2
5
28
34
68
31
55
53
37
49