Weslo Cadence 45 User Manual page 7

2. See the inset drawing. Identify the Right Upright (37),
which has a large round hole near the lower end, and the
Left Upright (32).
Have a second person hold the Base (55) so it is resting
on the Wheels (34) as shown. Attach the Right and Left
Uprights (32, 37) to the Base with four Upright Bolts (28),
four 3/8" Star Washers (90), and four Upright Nuts (49).
Do not tighten the Bolts yet. Make sure that the large
hole in the Right Upright is in the indicated location,
and that the two small holes in the Left Upright are in
the indicated location. In addition, make sure that the
Base is oriented so the Base Pads (31) are in the lo-
cation shown.
3. With the help of a second person, place the Frame (21)
between the Uprights (32, 37). Feed the Wire Harness
(53) into the large round hole near the lower end of the
Right Upright (37), and then pull the Wire Harness out of
the upper end as shown.
See drawing 3a. Raise the Uprights (32, 37) to the vertical
position. Hold an Upright Spacer (58) against one side of
the Frame (21) as shown. Insert a Frame Bolt (36) into the
indicated hole in the Upright Spacer and the Frame. Next,
tighten a Spacer Screw (40) into the Upright Spacer and
the Frame. Remove the Frame Bolt. Repeat on the other
side of the Frame.
With the help of a second person, carefully lift the Frame
(21), and hold the Upright Spacers (58) between the Right
Upright (37) and the Left Upright (not shown). Align the in-
dicated hole in the Right Upright with the hole in the right
Upright Spacer. Next, insert a Frame Bolt (36) with a 3/8"
Star Washer (90) into the Right Upright and the Upright
Spacer, and loosely thread the Upright Bolt into the Frame.
Repeat this step on the left side of the treadmill.
4. With the help of a second person, raise the Left and
Right Uprights (32, 37) to the vertical position.
Feed the Wire Harness (53) into the hole in the bottom of
one of the Handrails (4) and out of the large hole in the
side. Note: It may be helpful to use needlenose pliers to
pull the Wire Harness out of the hole.
Set the Handrail (4) onto the Right Upright (37). Attach
the Handrail with two Handrail Bolts (44) and two 5/16"
Star Washers (68). Firmly tighten the Bolts.
Attach the other Handrail (4) as described above. Note:
There is not a wire harness on the left side.
2
Small
Holes
28
90
28
90
Large
Hole
3
32
3a
58
21
4
4
44
32
7
28
90
32
28
55
90
49
37
49
Hole
31
34 37
21 53
37
53
37
40
Holes
53
Hole
44
68
Bracket
4
44
49
31
34
Hole
90
36
44
68
37