Installation Instructions; Step 1 Remove Packaging; Step 2 Install Leveling Legs; Step 3, Remove Access Covers - GE Monogram ZBD6400 Installation Instructions Manual

BEFORE YOU BEGIN:
CUSTOM PANEL INSTALLATION: If you intend to
install custom door panels, (on some models) refer to
trim kit installation instructions. Custom panels should
be in place before installing the dishwasher.

STEP 1 REMOVE PACKAGING

Cut the shipping carton and use it as a pad beneath the
dishwasher. This will protect the finished floor in the
kitchen.
• Remove wrapping and uncoil the drain hose in the
back of the dishwasher. Do not remove rear insulation
blanket.
• Lay the dishwasher on it's back. Do not kink or crush
the drain hose.

STEP 2 INSTALL LEVELING LEGS

Rear
Insulation
Blanket
• Measure installation opening from the floor to the
bottom of the countertop.
• Install the front leveling legs into holes on the brack-
ets. Use a wrench to screw the legs in until the overall
height of the dishwasher is 1/4" less than the installa-
tion opening height.
Note: Install the legs as shown, 1-1/4" min from the
bottom of the bracket.
• Remove and discard the red plugs from the front
holes.

Installation Instructions

1-1/4" Min.
Remove
Red Plugs
Unscrew
Rear Legs to
Installation
Height
STEP 3 REMOVE ACCESS COVER
• Remove sound insulation board and the access cover
plate.
• Install UL listed strain relief on junction box.

STEP 4 INSTALL 90 ELBOW

• Install the 90 elbow onto the water inlet. Use thread
seal tape or pipe thread compound. Thread seal tape
should be wrapped in same direction as the threads on
the elbow.
• The 90 elbow should face the inlet water line.
10
Insulation Board
Junction Box
Access Cover
90
Elbow
Thread
Seal Tape