Advertisement
ASSEMBLY
Place all parts of the rowing machine in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Read each step carefully before beginning.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS (NOT INCLUDED): An adjustable wrench
and a phillips screwdriver
1. Insert two new ÒAAÓ batteries (not included) into the
Monitor (15). Alkaline batteries are recommended.
Make sure that the batteries are turned as shown
inside the Monitor.
Insert the two tabs on the Monitor (15) into the slots
near the front end of the Rail (2). Attach the Monitor to
the Rail with the Monitor Screw (14).
2. Attach the Seat (23) to the Seat Bracket (24) with the
four Seat Screws (37). Note: The thickest part of the
Seat is the back. The Seat can be turned so the Seat
Knob (27) is on either the left or right side of the Seat.
3. Pull the Rail Cap (6) out of the back end of the Rail
(2). Remove the M8 Nylon Locknut (9), the Seat
Stops (5), and the Seat Stop Bolt (4) from the back
end of the Rail.
Roll the Seat (23) onto the Rail (2). Make sure that
the thickest part of the Seat is at the back.
Reattach the Seat Stop Bolt (4), the Seat Stops (5),
and the M8 Nylon Locknut (9) to the Rail (2). Press
the Rail Cap (6) back into the Rail.
.
1
2
3
14
2
23
24
37
2
9
5
5
4
15
Tabs
27
37
23
6
3
Advertisement
