Precautions - Panasonic FP-D355 User Manual

Precautions

For U.S.A.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his/her own
expense.
Any unauthorized changes or modifications to this equipment would void the users authority to
operate this device.
You need to read software license agreement before setting up the Printer Driver.
You need to read following precautions which describes in the Copier Operating Guide.
C Installation
C Ventilation
C Handling
C Toner and Paper
C Transportation
Precautions for hardware
C Precautions for the restriction of the use of the hard disk in the digital copier. Hard disk for this
unit is exclusively for the Printer. Do not use for other purpose by disassembling and/or
reconnecting cables. In that case, printer function may be failed..
C Data back up in the hard disk data
When repairing hard disk, it is for drive equipment only to repair or replace.
As it is not be possible to warranty or repair the saved data, always save back up data.
C Precautions when power switch of the digital copier is turned on/off.
Be sure never turn the power switch off while hard disk (HDD) is accessing or writing files.
This may cause the damage to the hard disk, and the data in the disk may be destroyed.
(If the power switch should turned off, turn on the power switch again after more than 15 seconds.
If data in the hard disk should be destroyed on that time, Panasonic will not bear any
responsibility.)
C When the digital copier is in operation, especially the hard disk is operating or just after the turning
off the power switch (approx. 10 sec.), do not move the digital copier.
(Wait until hard disk completely stops.)
3