Power Convertible Top Operation - Fiat 500 Abarth User Manual

OPERATING YOUR VEHICLE

POWER CONVERTIBLE TOP OPERATION

• The power top buttons will operate
when the ignition switch is turned to
the ON/RUN or ACC position and
when in the power accessory delay.
• The power top buttons are located on
the overhead console.
Lowering
• Press the top open button once for
the partially open position.
• Press the top open button a second
time to fully open the convertible top.
Raising
• From the convertible top fully open
position, press the top close button
once for the partially open position.
• Press the top close button a second time to partially close the convertible top.
• Press and hold the close button to fully close convertible top.
NOTE:
Rail lubrication is recommended every 2000 cycles, or if scratching noises due to
dust are present. Use Berulub FR 43 grease.
Power Convertible Top Relearn Procedure
• If your power convertible top does not operate in the Auto Open/Close mode
(automatically opening to the 1/4 open and 3/4 open comfort stops), or if the
trunk lid does not open - the following relearn procedure may be necessary.
1. Confirm that the doors and trunk lid are closed.
2. Begin with the top in the fully closed position (using manual mode).
3. Hold the OPEN button to move the top to the fully open position.
4. CONTINUE to hold the OPEN button for an additional three seconds.
5. Release the OPEN button.
6. Hold the CLOSED button to move the top to the fully closed position.
7. CONTINUE to hold the CLOSED button until the top begins to cycle fully open,
then release the CLOSED button.
• At the end of Step 7 the top will automatically cycle to the fully open position, and
then close to the 1/4 open position.
• This will confirm that the relearn procedure was successful.
• Auto Open/Close will now be functional. Trunk lid operation will be functional.
26