Chevrolet Uplander Owner's Manual page 113

Power Sliding Door Operation
The power sliding door(s) will only open if the transaxle
is in PARK (P). The transaxle does not have to be in
PARK (P) to close the door(s).
There are several ways to open and close the power
sliding door(s).
•
If your vehicle has a single power sliding door,
press the bottom of the overhead console PSD
activation switch.
•
If your vehicle has dual power sliding doors, press
the top of the driver's side and/or passenger's side
overhead console PSD switch.
•
Press the passenger PSD activation switch.
This switch will also stop a moving door
immediately.
•
Press the power sliding door button on the remote
keyless entry transmitter.
•
To manually open the power sliding door(s) while
the switch(es) are in the activation position, pull
and release the inside or outside door handle
to release the door latch. The door will fully open.
•
To manually close the power sliding door(s) while
the switches are in the activation position, pull the
inside or outside door handle or the edge of the
door. Move the door about 4 inches (10 cm) toward
the closed position and release it. The door will
close completely and latch.
If a power sliding door is locked, it cannot be unlocked
and opened using the overhead console PSD
activation switch(es) or the passenger PSD activation
switch(es). The power sliding door must either be
manually unlocked or unlocked using the power door
unlock switch located on the driver's or front passenger's
armrest, and then opened using the overhead or
passenger PSD activation switch(es).
The remote keyless entry transmitter can also be used to
open the power sliding door(s). If the vehicle is locked,
press the power sliding door button(s) and all doors will
unlock and the sliding door(s) will open. See Remote
Keyless Entry System Operation on page 2-5.
2-19