Trunk Configuration; Aggregator Setting; Lacp Configuration - ZyXEL Communications MES-2110 Support Notes

Managed 8-port 10/100 mbps plus 2-port gigabit dual personality access switch

Hide thumbs Also See for MES-2110:

Table of Contents

MANAGED 8-PORT 10/100 + 2 G DUAL PERSONALITY SWITCH

2.10 Trunk Configuration

2.10.1

Port Trunking defines a network link aggregation and trunking method which specifies

how to create a single high-speed logical link that combines several low-speed physical

links. Use the Trunk Configuration page shown above to create trunk groups. The

Switch supports a maximum of four trunk groups for 100Mbps ports and an additional

trunk group for Gigabit ports. 100Mbps ports and Gigabit ports cannot be grouped

together. Each trunk group in groups 1~4 may be comprised of up to four ports,

selected from any combination of 100Mbps ports. Trunk Group 5 can only consist of the

two Gigabit Dual Personality ports.

If the trunk group formed with another switch using protocol-based LACP, click to

enable "LACP".

2.10.2

"Port State Activity" will determine whether the port will actively initiate the LACP

negotiation. Enable "Active" if the port is active for LACP negotiation.

Hash-mode can determine either Xor or Lookup method to calculate which port the

traffic will forward to.

System priority is combined with the Switch's MAC address to form the Link Aggregation

Group (LAG) ID. This ID is used to indicate a specific LAG during LACP negotiations

with other systems.

Table of Contents