General / System Set-Up; Introduction; Personnel Safety; Ordering Replacement Parts - Kenwood TK-5210 Service Manual

TK-5210

INTRODUCTION

SCOPE OF THIS MANUAL
This manual is intended for use by experienced techni-
cians familiar with similar types of commercial grade commu-
nications equipment. It contains all required service informa-
tion for the equipment and is current as of the publication
date. Changes which may occur after publication are covered
by either Service Bulletins or Manual Revisions. These are
issued as required.

ORDERING REPLACEMENT PARTS

When ordering replacement parts or equipment informa-
tion, the full part identification number should be included.
This applies to all parts : components, kits, or chassis. If the
part number is not known, include the chassis or kit number
of which it is a part, and a sufficient description of the re-
quired component for proper identification.
Model &
Destination (Market code)
K
TK-5210 K2
K3
SYSTEM SET-UP
Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
Delivery
2

GENERAL / SYSTEM SET-UP

Unit X57-682X-XX
0-10 0-11 0-12
✓
✓
✓
A personal computer (IBM PC or compatible), programming
interface (KPG-36), and programming software (KPG-95D)
are required for programming.
(The frequency, and signaling data are programmed for the
transceiver.)
YES
NO
YES
NO

PERSONNEL SAFETY

The following precautions are recommended for person-
nel safety:
• DO NOT transmit until all RF connectors are verified se-
cure and any open connectors are properly terminated.
• SHUT OFF and DO NOT operate this equipment near elec-
trical blasting caps or in an explosive atmosphere.
• This equipment should be serviced by a qualified techni-
cian only.
SERVICE
This transceiver is designed for easy servicing. Refer to
the schematic diagrams, printed circuit board views, and
alignment procedures contained within.
Frequency range Remarks
1st IF:49.95MHz
136~174 MHz
LOC:50.4MHz
Frequency range (MHz) RF power
TX/RX 136~174 5W
TX/RX 136~174 5W
TX/RX 136~174 5W
KRA-22 or KRA-26
Helical antenna
(Option)
KMC-25
(Option)
LCD 4-key
keypad
- -
✓ ✓
✓ ✓
Type LCD 4-key DTMF keypad
TK-5120 K No No
TK-5120 K2 Yes Yes
TK-5120 K3 Yes Yes
DTMF
-
-
✓
No
No
Yes