General / System Set-Up; Service; System Set-Up - Kenwood TK-7180 Service Manual

Kenwood vhf fm transceiver service manual
Hide thumbs Also See for TK-7180:
Table of Contents

Advertisement

SERVICE

This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
NOTE
• If you do not intend to use the speaker 3.5-mm jack and
the D-sub 25-pin connector, fit the supplied speaker-jack
cap and D-sub cap to stop dust and sand from getting in.
• If the transceiver is turned ON or OFF when the power-on/
off status message is enabled, the transceiver sends the
status.

SYSTEM SET-UP

License and frequency allocated by FCC

GENERAL / SYSTEM SET-UP

Merchandise received
Choose the type of transceiver
YES
Are you using
the remote kit?
NO
Are you using
YES
the ignition sense cable?
NO
Transceiver programming
Are you using
YES
the radio interface cable?
NO
Are you using
YES
the public address?
NO
Are you using
YES
the voice guide & storage
unit?
NO
Are you using
YES
the external speaker?
NO
Are you using
YES
the keypad microphone?
NO
Supplied microphone
Delivery
Antenna
connector
Frequency range
RF power
136~174MHz
30W
KRK-10
(Option)
KCT-46
(Option)
See page 4.
A personal computer (IBM PC or compatible), programming
interface (KPG-46), and programming software (KPG-89D)
are required for programming.
KCT-40
(Option)
KCT-36 Extension cable
KGP-2A
KDS-100
or
Mobile data terminal
Modem GPS receiver
or
KGP-2B
Modem GPS controller
(Option)
KAP-2
(Option)
VGS-1
(Option)
KES-3 or KES-5 External speaker
(Option)
KMC-32 or KMC-36
(Option)
Desk top microphone KMC-9C
TK-7180
Speaker
jack cap
Ignition
sense cable
Power input
connector
Type
K
See page 9.
See page 7.
See page 7.
(Option)
(Option)
See page 8.
See page 10.
D-sub
cap
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents