Installing, Setting Up Software; Installing The Share Button App - Kodak EASYSHARE Z5120 Extended User Manual

2

Installing, setting up software

Before you can share pictures/videos, you must:
Install the KODAK Share Button App on your computer
■
See

Installing the Share Button App

■ Perform a one-time setup of your email and social networking site credentials (user
IDs and passwords). The email addresses and sites that you choose will appear on
your camera when you press the Share button.
See Setting up the Share Button App (one-time setup), page 8
Installing the Share Button App
IMPORTANT: Until you install and set up the Share Button App, the camera Share button
is not enabled.
1 Make sure the computer is connected to the Internet.
2 Turn off the camera.
If you successfully installed the software
See "Setting up the Share Button App (one-time setup)" on page 8.
www.kodak.com/go/support
(below) and
3 Using the USB cable, connect the camera to a
computer USB port. Then turn on the camera.
The Camera Setup App runs. (If there are many
pictures on your memory card, this step could take
several minutes.)
4 Watch your computer—when the Camera Setup
App prompts you to install the Share Button App,
click Install Now. (If you are prompted to allow the
Camera Setup App to run, click Allow.)
5 When prompted, click Finish.
7