Safety Instructions - Sagem 1201 Quick Installation Manual

5 SAFETY InSTRUCTIonS

Environment
 the modem should be installed and used inside a building.
 the room temperature should not exceed 45ºC.
 The modem can be placed on a desktop or fixed vertically in its wall mounting.
 the modem should not be exposed to strong sunlight or placed near a substantial
source of heat.
 the modem should not be placed in an environment where it would be subjected to
considerable steam condensation.
 the modem should not be exposed to splashes of water.
 the modem's casing should not be covered.
 the modem and its peripherals should not be used for outdoor transmissions.
power supply source
 the modem's mains adapter should not be covered.
 the modem comes with its own mains adapter. it should not be used with another
adapter.
 this class ii adapter does not need to be grounded (earthed). the connection to the
electrical network should comply with the indications given on the label.
 use a readily accessible mains outlet located near the modem. the power supply cord
is 2 m long.
 arrange the power supply cord in such a way as to avoid any accidental power cut to
the modem.
 the modem is designed to be connected to a gg- (ground-to-ground) or gn- (ground-
to-neutral) type power supply network.
 the modem is not designed to be connected to an electrical installation with it type
diagram (neutral connected to earth through an impedance).
 protection against short-circuits and leaks between phase, neutral and earth should be
provided by the building's electrical installation. the power supply circuit for this
equipment should be fitted with 16 A overcurrent protection and differential protection.
 the modem should be connected to the mains via a readily accessible wall socket
ensuring the electric cutting.
Maintenance
 It is prohibited to open the casing. This must be done only by qualified personnel appro-
ved by your supplier.
 do not use liquid or aerosol cleaning agents.
253156400-A_GIR 1201 V2 STD-gb.i15 15
SAGEM F@st™ 1201/1241 V2
13
Safety instructions
14/10/2008 17:00:08