Canon PIXMA iP6600D Service Manual page 12

*2
[1841]
Inner cover open during
printing on paper.
*2
[1846]
Inner cover open during
printing on paper (print
*1
continuable). [1851]
Inner cover open during
printing on paper (print
NOT continuable).
*1
[1856]
Inner cover closed
during CD / DVD
printing (print
*1
continuable). [1850]
Inner cover closed
during CD / DVD
printing (print NOT
*1
continuable). [1855]
Multiple ink tanks of
the same color installed.
[1681]
Ink tank in a wrong
position. [1680]
Warning: The waste
ink absorber becomes
almost full. [1700]
The connected digital
camera or digital video
camera does not
support Camera Direct
Printing. [2001]
Automatic duplex
printing cannot be
performed. [1310]
Failed in automatic
print head alignment.
[2500]
inner cover and press [OK].
Open the inner cover, place the
CD-R tray and press [OK].
(Applicable ink tank icon)
More than one ink tank of the
following color is installed.
Some ink cartridges are not
installed in place.
The waste ink absorber is almost
full. Press [OK] to continue but
early replacement recommended.
<See manual>
Incompatible device detected.
Remove the device.
This paper is not compatible with
duplex printing. Remove the
paper and press [OK].
Auto head align has failed. Press
[OK] and repeat operation. <See
manual>
the Stop/Reset button.
Close the inner cover, and press
the Stop/Reset button.
Close the inner cover, and press
the Stop/Reset button.
Close the inner cover, and press
the Stop/Reset button to clear the
error. The paper being printed at
error occurrence will be ejected
without printing the remaining
data for the ejected paper, then
printing will resume from the
next page.
Open the inner cover which
functions as the CD / DVD tray
feeder, set the CD / DVD tray in
the feeder, and press the
Stop/Reset button.
Open the inner cover, and press
the Stop/Reset button to clear the
error. The CD or DVD being
printed at error occurrence will
be ejected without printing the
remaining data for the ejected
CD or DVD, then the next print
job will be done.
Replace the wrong ink tank(s)
with the correct one(s).
Install the ink tank(s) in the
correct position.
Press the Stop/Reset button.
Remove the cable between the
camera and the printer.
Press the Stop/Reset button to
eject the paper being used at error
occurrence. Printing will resume
from on the front side of the next
page.
Press the Stop/Reset button.
- If paper is being fed at error
occurrence, the error is
indicated after the paper is
ejected.
- If the error occurs, the print
head alignment values are not
changed.
- After exit from the error by the
Stop/Reset button, the
automatic print head alignment
will not be re-done.
1-6
The service call error,
indicating the waste ink
absorber is full, is likely
to occur soon.
Data which was to be
printed on the back side
of paper at error
occurrence is skipped
(not printed).
The error is indicated
when the pattern is not
printed due to no ink or
non-ejection of ink, or
when the sensor's AD
value is incorrect.