Bosch FMM‑462 Series Use And Installation Manual

Fire Alarm Systems | FMM‑462 Series POPIT Addressable Manual Stations
FMM‑462 Series POPIT Addressable
Manual Stations
www.boschsecurity.com
The FMM‑462 Series Addressable Manual Stations
allow people evacuating a building to initiate an alarm
and alert others still inside. This UL-listed initiating
device is compatible with the Bosch Security Systems,
Inc. G Series Control Panels and the D9124 Fire Alarm
Control Panel (FACP).
The POPIT module is addressed using on-board slide
switches. It is then connected to a D9124 data
expansion loop. The POPIT is polled by the control
panel and sends reports on any opens, shorts, or
ground faults on the manual station's wiring. The
addressable feature allows the agencies responding to
alarm or trouble conditions to go to the point that
initiated the alarm or trouble report.
These low-profile manual stations are die cast with
rounded edges to fit most design applications. All
metallic components are painted or plated to inhibit
corrosion. The FMM‑462 Series Manual Stations
conform with the Americans with Disabilities Act
(ADA) standards.
Single‑gang mounting
u
Latching alarm lever and key‑locked reset
u
Rugged die‑cast housing with 14 gauge (1.9 mm)
u
plated steel back and corrosion‑resistant
construction
Optional scored acrylic breakrod
u
Functions
Addressable Operation
The POPIT connects to a two‑wire data expansion
circuit from the control panel. Device address is set
through slide switches on the POPIT Module, allowing
programmable device identification by the control
panel.
Certifications and Approvals
ADA
NFPA
Region Certification
USA UL UNIU: Boxes, Non-Coded (UL38)
CSFM 7150-1615:0122
Complies with Americans with
Disabilities Act ADA 4.28.3
Complies with National Fire
Protection Association NFPA 72