ProForm 385rp User Manual page 6

3. With the help of a second person, lift the Right Handrail (32)
off the right Upright (14). Hold the Console Base (6) and the
Right Handrail in the position shown. Feed all of the excess
Wire Harness (26) into the Right Handrail (32) and through
the indicated bracket. Make a fold in the Wire Harness (26)
as shown. Feed the Harness and fold into the right Upright.
Cut the indicated plastic tie off the Right Handrail (32).
Make sure that the Wire Harness (26) is in the bracket and
insert the bracket into the right Upright (14). Make sure
that the Wire Harness is not pinched.
4. Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the right Upright (14) and the Right Handrail (32). Do
not tighten the Handrail Bolt yet.
Attach the lower end of the Right Handrail (32) to the right
Extension Leg (41) with a 3 1/2Ó Handrail Bolt (89), a 3/8Ó
Washer (70), and a Handrail Nut (57).
Tighten all parts used in this step and in step 2.
5. Attach the Console Base (6) to the Left and Right
Handrails (2, 32) with four 3/4Ó Screws (13).
The console requires two "AA" batteries (not included);
alkaline batteries are recommended. To install batteries,
open the battery cover as shown at the right. Press the
batteries into the battery compartment, with the negative
(Ð) ends of the batteries touching the springs. Close the
battery cover, push up on the tab, and then push the tab
forward. Be sure that the tab locks into place.
6. Attach the Storage Latch (12) to the left Upright (14) with
two 3/4Ó Screws (13). Be careful not to overtighten the
Screws.
7. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place
a mat under the treadmill.
3
6
Bracket
32
26
4
57
5
32
13
6
6
Plastic Tie
14
15
16
32
14
41
70
89
9
6
Batteries
2
14
13
12
Tab
13