Management - Bosch DVA-16K SCSI Installation Manual

RAID Subsystem DVA-16K | Installation Manual
Two (2) dual-stacked VHDCI SCSI connectors connect the RAID controller to single or dual
hosts and cascade external devices. Two (2) hot-swappable cooling modules protect the sub-
system from overheating, and two (2) hot-swappable power supply unit (PSU) modules pro-
vide constant power to the subsystem. The modular nature of the subsystem and the easy
accessibility to all major components ensure the ease of the subsystem maintenance.
NOTICE!
i
On receiving and unpacking your subsystem, please check the package contents against the
included Unpacking Checklist. If any modules are missing, please contact your subsystem ven-
dor immediately.
2.2

Management

The RAID subsystem can be managed using either the firmware or the Bosch RAIDWatch web-
based GUI. The firmware can be accessed by using either the LCD panel (see Figure 2.2)
located at the front of the subsystem or a terminal emulation program installed on an external
computer and connected to the COM1 on the controller module's rear panel (see Figure 2.2)
with the provided serial cable.
Fig. 2.2 Controller Module Rear Panel
If web-based management is desired, connecting the subsystem to the world wide web
through the Ethernet port on the controller module's rear panel, (See Figure 2.2) allows you to
manage the RAID subsystem by Bosch RAIDWatch management software.
Bosch Security System
Introduction | en 9
F.01U.027.799 | V2 | 2008.08