Hardware Installation; Introduction; Installation Prerequisites - Bosch DVA-16K SCSI Installation Manual

Raid subsystem scsi premium series
Hide thumbs Also See for DVA-16K SCSI:
Table of Contents

Advertisement

RAID Subsystem DVA-16K | Installation Manual
3

Hardware Installation

3.1

Introduction

This chapter gives detailed instructions on how to install the subsystem. When installing the
subsystem, it is necessary to install the controller module, hard drives, and drive trays. Instal-
lation into a rack or cabinet should occur before the hard drives or drive trays are installed
into the subsystem. Please confirm that you received all of the components listed on the
Unpacking List that came with the subsystem before proceeding with the installation process.
CAUTION!
Please note that the installation instructions described in this manual should be carefully fol-
lowed to prevent any difficulties and damages to your system.
3.2

Installation Prerequisites

1.
2.
3.
4.
5.
6.
Bosch Security System
Static-free installation environment: The RAID subsystem must be installed in a static-free
environment to minimize the possibility of electrostatic discharge (ESD) damage. (See
Section 3.3.2 Static-free Installation)
Component check: Before installing the RAID subsystem, you should first check to see
that you have received all the required components. (See Section 3.5 Unpacking the Sub-
system) If any items appear damaged, contact your vendor for a replacement.
Hard drives: Up to sixteen (16) SATA-I or SATA-II hard drives must be purchased sepa-
rately prior to the RAID subsystem installation.
Cabling: The RAID subsystem requires an external VHDCI to VHDCI SCSI round cable to
connect the subsystem to a host computer. Please see Section 5 Subsystem Connection
and Operation for sample topologies and configuration options.
Memory module: If you wish to change the pre-installed memory module, a separately
purchased module must be installed. (See Section 6.3 DIMM Module Replacement)
Rack installation: The enclosure chassis can be installed into rack cabinet using sepa-
rately purchased mounting rails, rear-attached brackets, or Bosch's slide rails. (See
Section 3.6 Rack/Cabinet Installation)
Hardware Installation | en
19
F.01U.027.799 | V2 | 2008.08

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dva-16k series

Table of Contents