Mounting The Base Directly On The Wall - Radio Shack TAD-732 Owner's Manual

43-732.fm Page 10 Friday, August 13, 1999 1:42 PM
5. Route the end of the modular cord
through the hole in the bracket, and
insert the tabs on the narrow end of
the bracket into the inner pair of
slots near the top of the base as
shown.
6. Snap the tabs at the wide end of the
bracket into place.
7. Plug the modular cord into the wall
plate jack. Align the base's keyhole
slots with the wall plate studs and
slide the base downward to secure
it.
10
8. Plug the AC adapter into a standard
AC outlet. The TAD-732 beeps and
00 appears.
9. Raise the base's antenna to a verti-
cal position.
Mounting the Base Directly on
the Wall
To mount the base directly on the wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on
the bottom of the base.