GE UNITIZED SPACEMAKER WSM2700/80D Product Information

GE Appliances
WSM2700/80D – GE 27" Unitized Spacemaker
®
Dimensions (in inches)
Vent 9-3/8
(rear
only)
54-5/16
Water inlets 5-1/4
(rear)
75-1/2
41-1/4
Drain outlet
29-7/16
(rear)
3-3/4
27
Power Cord Location
Power
Cord Hole
12-1/2''
41''
Back View
Specification Created 6/03
16-1/4
Gas supply
pipe (rear)
o
51
43
36-1/16
30-13/16
Washer and Dryer
®
Electrical Requirements:
25-1/4
WSM2700D Electric Dryer – This appliance should be connected to an individual,
2-1/2
properly-grounded branch circuit with 120/240V or 120/208V single-phase 60 Hz
electrical service and should be protected by 30-amp time-delay fuses or circuit
47
breakers. This appliance is manufactured with neutral connected to the frame.
Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
WSM2780D Gas Dryer – This appliance should be connected to an individual branch
4-13/16
circuit with 120-volt single-phase 60 Hz electrical service and should be protected
by 20-amp time-day fuses or circuit breakers. This appliance is equipped with a
4-foot long flexible U.S. listed 20-amp power cord to match a 20-amp receptacle.
11-7/16
Note:
Gas Rated input 20,000 BTU/HR. Factory equipped for natural gas. Tested for LP
gas. LP gas supply requires a conversion kit. Have a qualified gas technician
install a conversion kit before use.
Exhaust Information:
Exhausting the dryer to the outside is strongly recommended to prevent large amounts
of moisture and lint from being blown into the room. Closet installations must be
exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with the product.
R
For answers to your Monogram,
GE ® appliance questions, visit our website at
Listed by
Underwriters
GEAppliances.com or call
Laboratories
GE Answer Center ® service, 800.626.2000.
® GE Profile ™ or