WSM2700/80H
GE
27" Unitized Spacemaker
®
Dimensions and Installation Information (in inches)
Electrical Requirements:
WSM2700H Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V or 120/208V
single-phase 60 Hz electrical service and should be protected by
30-amp time-delay fuses or circuit breakers KW Rating per voltage
(240/208). This appliance is manufactured with neutral connected to the
frame. Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
WSM2780H Gas Dryer – This appliance should be connected to an
individual branch circuit with 120-volt single-phase 60 Hz electrical
service and should be protected by 20-amp time-day fuses or circuit
breakers. This appliance is equipped with a 4-foot long flexible U.S. listed
20-amp power cord to match a 20-amp receptacle.
Note:
Gas Rated input 20,000 BTU/HR. Factory equipped for natural gas. Tested
for LP gas. LP gas supply requires a conversion kit. Have a qualified gas
technician install a conversion kit before use.
Dryers must be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with
the product.
For answers to your Monogram,
GE Profile
®
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
800.626.2000.
Washer and Dryer
®
Model WSM2420
Power
Cord Hole
9-1/2
41-1/2
or
™
service,
Back View
Unitized Models WSM2700R and WSM2780R
Dimensions (in inches)
Vent
9-3/8
(rear
only)
54-5/16
Water inlets
5-1/4
(rear)
75-1/2
41-1/4
Drain outlet
29-7/16
(rear)
3-3/4
27
Model WSM2700
Power Cord Location
WSM2700/2780R Uni. Wash/Dry
Power
Cord Hole
12-1/2
41
Back View
16-1/4
Gas supply
pipe (rear)
51
43
36-1/16
Specification Revised 5/09
25-1/4
2-1/2
47
o
4-13/16
11-7/16
30-13/16
Listed by
Underwriters
Laboratories
360326