Symbols; Additional Warnings For String Trimmers; Polarized Plugs; Extension Cords - Black & Decker GH3000 Instruction Manual

circuit(s) or outlet(s) to be used for the appliance. Receptacles are available having built-in
GFCI protection and may be used for this measure of safety.
• DON'T ABUSE CORD – Never carry appliance by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil, and sharp edges.
• REPLACEMENT PARTS – When servicing use only identical replacement parts.
• MAINTAIN APPLIANCES WITH CARE – Follow instructions in maintenance section. Keep
handles dry, clean and free from oil and grease.
• CHECK DAMAGED PARTS – Before further use of the appliance, a guard or other part
that is damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition that may affect its operation. A guard
or other part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in this manual.
• DO NOT immerse appliance in water or squirt it with a hose. DO NOT allow any liquid to get inside it.
• DO NOT store the appliance on or adjacent to fertilizers or chemicals.
• DO NOT clean with a pressure washer.
• Keep guards in place and in working order.
• Keep hands and feet away from cutting area.
WARNING:
Do not use appliance if the switch trigger does not turn the appliance on or off.
Any appliance that can not be controlled with the switch trigger is dangerous and must be repaired.

SYMBOLS

The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V ..................volts
Hz ................hertz
min..............minutes
.............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)

ADDITIONAL WARNINGS FOR STRING TRIMMERS

1. Keep the air intake slots (Figure H2) clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition, store spare pre-
wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. DO NOT immerse appliance in water or squirt it with a hose. DO NOT allow any liquid to get inside it.
5. Do not store the appliance on or adjacent to fertilizers or chemicals.
6. DO NOT clean with a pressure washer.
7. The line cutter on the edge of the guard can dull over time.
SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS
CAUTION:
To reduce the risk of electric shock, this equipment has a polarized plug (one blade
is wider than the other) and will require the use of a polarized extension cord. The appliance plug will fit
into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse
the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension
cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one
way. If the plug does not fit fully into the wall outlet, reverse the plug. If the plug still does not fit, contact
a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord
receptacle, or extension cord plug in any way.
SAFETY WARNINGS AND INSTRUCTIONS: EXTENSION CORDS
WARNING:
To reduce the risk of electric shock, use only with an extension cord
intended for outdoor use, such as
an extension cord of cord type
SW-A, SOW-A, STW-A,
STOW-A, SJW-A, SJOW-A,
SJTW-A. or SJTOW-A.
Make sure your extension cord is
in good condition. When using an
extension cord, be sure to use one
SAVE THESE INSTRUCTIONS
Volts
120V
Ampere Rating
More
Than
6 -
A ..................amperes
W ..................watts
................alternating current
n o.................no load speed
.................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0-25 26-50
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Not more American Wire Gauge
Than
10 18 16
5
51-100 101-150
14 12