Replacing The Filters - Black & Decker PHV1210, PHV1810 Instruction Manual

• The dust container (11) is attached to the
body of the appliance with a bayonet
fixing. To remove the dust container,
press the dust container release button
(2) and rotate the dust container (11)
counterclockwise and carefully slide the
dust container clear of the appliance.
• Rotate the filter hook (12) to the vertical
position (fig. I).
• Use the filter hook (12) to rotate the filter
(13) within the pre-filter (14) to agitate it
and remove dirt.
• Remove the main filter (13).
• Brush any loose dust off the filter (13).
• The pre-filter (14) is attached with a
bayonet fixing. To remove the pre-filter, rotate
the pre-filter (14) counterclockwise and
carefully slide it clear of the dust container.
• The dust container can be cleaned.
Wipe with a damp cloth or rinse with
warm soapy water and allow to dry.
• The filters are re-usable and should be
cleaned regularly. Rinse with warm
soapy water and allow to dry.
• Install the pre- filter (14) into the dust
container (11) rotating it clockwise until it
locks into place.
• Install the main filter (13) into the
pre-filter (14).
• Install the dust container (11) to the
appliance, rotate it clockwise until it locks
into place.
wARNING:
without the filters. Optimum dust collection will only be achieved with clean filters.

Replacing the filters

The filters should be replaced every
6 to 9 months and whenever worn or
damaged. Replacement filters are available
from your Black & Decker dealer (cat. no.
PVF110):
• Remove the old filters as described
above.
• Fit the new filters as described above.
G
H
Projectile/Respiratory Hazard: Never use the appliance
I
6