Navigation System (Optional); Switching The Navigation Screen (Optional); Auxiliary Device (Optional); Operating Auxiliary Devices (Optional) - Alpine IVA-D310RB Owner's Manual

Navigation System
(Optional)
Switching the Navigation Screen
(Optional)
If an optional Alpine Navigation System is connected to the IVA-
D310R/IVA-D310RB, the Navigation screen can be displayed on this
unit.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
Touch [NAV].
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner's Manual of the
navigator.
• While the Navigation selection mode is being selected in "Setting the
VISUAL Touch Button" (page 36), the navigation mode will be
directly activated.
• If the Navigation mode menu is not displayed on the main menu
screen, set NAV. IN to on by following "Setting the Navigation
Mode" (page 34).
• When the Navigation System is on, the audio and visual navigation
cuts in.
54
-EN
Auxiliary Device
(Optional)

Operating Auxiliary Devices (Optional)

To operate your devices connected to the AUX terminals on the rear
panel of IVA-D310R/IVA-D310RB, follow the procedure described
below.
WARNING
It is dangerous for the driver to watch the TV/Video
while driving the vehicle. The driver may be distracted
from looking ahead and an accident could occur.
Install the IVA-D310R/IVA-D310RB correctly so that
the driver cannot watch TV/Video unless the vehicle
is stopped and the emergency brake is applied.
If the IVA-D310R/IVA-D310RB is not installed
correctly, the driver will be able to watch the TV/Video
while driving the vehicle and may be distracted from
looking ahead and cause an accident. The driver or
other people could be severely injured.
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
Touch [AUX]*.
The external input screen is displayed.
3
Touch [NTSC/PAL] to change the video input.
* AUX-1 to AUX-3 are displayed if the external input devices
(maximal 3) are connected, or the name which is given as the source
name in "Naming External Devices" on page 35 is displayed.
• If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following "Setting the AUX Mode" (page 35).
• The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in "Switching the Visual Input
Signal" on page 35.
• The display mode changes by touching [WIDE].
For operation, refer to "Switching Display Modes" on page 26.