Rear Panel - Iomega StorCenter px12-450r User Manual

Iomega StorCenter px12-450r User Guide
Refer to the list of qualified hard disks on the Iomega support site at
before adding new drives.
2. Drive Status Indicator —

Solid blue — drive at speed; no faults

Flashing blue — drive is in RAID rebuild mode

Solid red — drive failure.

Off — drive is spun down in energy-saving mode
3. Drive Activity Indicator —

Flashing white — activity in process for the drive's RAID set

Off — no activity to the drive's RAID set

Rear Panel

.
1. AC Power Connectors — Connect both AC power connectors to an Uninterruptable Power Supply
(UPS) to provide redundant power for your px12-450r. The AC power supply will automatically switch
to the correct voltage for your region.
2. Power Supply — The px12-450r has redundant hot-swappable power supplies. If one power supply
fails, the other power supply will immediately take over. For maximum time-up, a failed power
supply can be replaced while the px12-450r is running.
3. System ID LED — Flashes blue when the Blink Lights feature is enabled in the Iomega StorCenter
px12-450r Console. This light is used to identify a specific px12-450r in installations with multiple
devices.
4. Reset Button — Press the Reset button to reset security and network settings. This allows you to
regain access if network settings are incorrect or you've forgotten your password. Note: The Reset
button does not initiate a full factory reset. To perform a full factory reset, select Factory Reset
from the System page in the Iomega StorCenter px12-450r Console
5. USB 2.0 connectors — Supports devices such as USB storage devices and printers.
6. Gigabit Ethernet Ports — High-speed Ethernet connectors that automatically detect your network
speed (10/100/1000Base-T).
7. VGA output connector — Connect a monitor for video surveillance applications.
150
www.iomega.com/nasdisks