Auto Search Method - Universal Remote Control UR3-SR3 Operating Manual

three-digit code number from the same brand list.
C. Auto Search Method
C. Auto Search Method
If none of the three digit code numbers assigned to your
brand of equipment works, or the code table does not list your
brand, you can use the Auto Search Method to find the
correct three-digit code number for your equipment by
following steps:
STEP1
Turn on the equipment that you want the remote
control to operate (Cable Box, TV, VCR, or DVD).
STEP2
Press the [DEVICE] button and the [OK/SEL]
button simultaneously for 10 seconds. The device
LED will turn on indicating that it is ready to be
programmed. The LED will remain on for 20
seconds. The next step must be entered while
the LED is on.
STEP3
Press the [CH+] or [CH-] button one at a time or
keep it pressed. The remote will emit a series of
Power ON/OFF code signals. Release the [CH+] or
[CH-] button as soon as the equipment turns off.
*Note : You can verify that you selected the correct code
by pressing the [MUTE] button. The equipment
should turn On or Off.
STEP4
Press the same [DEVICE] button to store the
code. The Device LED will blink twice to confirm
that the code has been stored.
D. To find the Three-Digit Code that Was
D. To find the Three-Digit Code that Was
Programmed using the Auto Search
Programmed using the Auto Search
Method
Method
STEP1
Press the appropriate [DEVICE] button and the
[OK/SEL] button simultaneously for 10 seconds.
The device LED will turn on for 20 seconds.
The next step must be performed while the
LED is on.
STEP2
Press the [INFO] button. The device LED will blink
a number of times indicating the number of each
4