Air Direction - GE AJCH 08 ACB, AJCH 10 ACB, AJCH 10 DCB, AJCH 12 DCB, AJCQ 06 LCB, AJCQ 08 ACB, AJCQ 10 ACB, AJCQ 10 DCB, AJCQ 12 DCB, AJCS 06 LCB Owner's Manual

Ge room air conditioner cool only, heat/cool, heat pump owner's manual
Hide thumbs Also See for AJCH 08 ACB, AJCH 10 ACB, AJCH 10 DCB, AJCH 12 DCB, AJCQ 06 LCB, AJCQ 08 ACB, AJCQ 10 ACB, AJCQ 10 DCB, AJCQ 12 DCB, AJCS 06 LCB:
Table of Contents

Advertisement

Available languages

Available languages

Fan Switch
To reach the fan switch(es) remove the
front grille.
On Heat/Cool and Heat Pump models, the fan switch
levers are located in holes accessed through the
control box. The top switch is for COOL settings
and the bottom switch is for HEAT settings.
Use a small screwdriver to change the setting.
The unit is shipped from the factory set in the
CONT setting for COOL and in the CYCLE setting
for HEAT.
Cool only models have a rocker switch on the
front of the control box.
When set at CYCLE (down) the fan cycles on and
off when cooling. When set at CONT (continuous,
up) the fan runs all the time, providing a more
balanced temperature. The unit is shipped in
the CONT setting.
Temperature Limiting
Limiting the maximum and minimum settings
prevents users from turning the control to the
extreme heat or cool positions.
The normal range of the temp control is
approximately 60°F to 85°F. The control range
may be narrowed by the use of the temperature
limiting screws located behind the control panel.
Vent Control
The vent control is located behind the front
grille on the right side of the air discharge area.
When set at CLOSE, only the air inside the room
will be circulated and conditioned. When set at
OPEN, some inside air is exhausted outside.
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove vent card, turn it over and replace
it by locating rear hole in card over locating
pin inside air discharge and reattaching
screw at front.

Air Direction

The unit leaves the factory set at the CLOSE position.
Horizontal louvers
on the front grille
let you control the
air direction up
and down.
(Depending on model)
Limits
heat
temp
Each position equals approximately 3°F.
Locating hole
Screw hole
OPEN position
(Mesh end toward back)
ge.com
or
Limits
cool
temp
Locating hole
Screw hole
CLOSE position
(Mesh end toward front)
Remove the front
grille to adjust the
vertical louvers
side-to-side to
direct the air left
or right.
9

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents