Healthrider H67e Elliptical User Manual page 8

4. Tip: Avoid pinching the Main Wire (60). Insert
the Upright (5) into the Main Frame (1).
Attach the Upright (5) with four M8 x 16mm
Screws (102) and four M8 Split Washers (103);
do not tighten the Screws yet. You will
tighten the Screws at the end of step 11.
5. Using a small plastic bag to keep your
fingers clean, apply a coat of the included
grease to the Upright Axle (48) and to two Wave
Washers (118).
Tip: Avoid damaging the Main Wire (60). Insert
the Upright Axle (48) through the Upright (5) and
center it. Slide a Wave Washer (118) onto each
side of the Upright Axle.
Next, identify the Right and Left Upper Body
Legs (6, 7) and orient them as shown.
Slide the Right and Left Upper Body Legs
(6, 7) onto the right and left sides of the Upright
Axle (48).
Tighten an M8 x 16mm Screw (102) and an M8
Washer (95) into each end of the Upright Axle
(48) at the same time.
4
60
5
103
102
1
5
60
102
95
118
7
Grease
8
Avoid pinching the
Main Wire (60)
102
103
103
102
103
102
Avoid damaging the
Main Wire (60)
5
Grease
48
118
6
102
95