Bowflex Ultimate 2 Accessory Pack Assembly Instructions Manual page 6

step
3 Parts:
• Base Plate (#11)
• Curl Mount (#6)
Hardware
• 7/8" Bolts (#12)
• Washers (#15)
Tools:
• Allen wrench (7/32")
Attach the Preacher Curl Mount (#6) to the Base
3-1
Plate (#11) using the hardware as shown in Figure
3. The Curl Mount should lean toward the U-shaped
bars on the Base Plate.
Tighten hardware completely.
step
Parts:
4
• Base Plate assembly from Step 3
• Base assembly from Step 2
Hardware
• 2 3/4" Bolts (#13)
• Washers (#15)
• Nuts (#14)
Tools:
• Allen wrench (7/32")
• Wrench/Socket (9/16") or Open End Wrench
Place the Base Plate (#11) on the lower
4-1
Side Tubes (#9), narrow edge toward the
Tube uprights and the curved edges outside
the Side Tubes. Align bolt holes in the Base
Plate and Side Tubes. Install the hardware
in the two bolt holes closer to the uprights.
See Figure 4.
At the bolt holes farther from the Side Tube uprights, insert a 2 3/4" Bolt (#13) through a Washer (#15) into
4-2
each bolt hole.
Carefully tilt the base assembly forward to rest on the four Side Tube ends. Install a Washer (#19) and
4-3
Nut (#18) onto each of the Bolts from Step 3-2.
Note: Do not tighten hardware at this time.
Turn the base assembly upright to rest on all four feet.
4-4
6
Qty
2
2
Qty
4
8
4
�
��
��
Figure 3
��
��
��
Figure 4
��
�
��
��