Bowflex BodyTower Assembly Manual page 10

Step 4: Install the E-Z Adjust Bar Assembly on the Uprights
Remove the Locking Pins (7a) from E-Z Adjust brackets before you install the assembly on
the Uprights. Tilt the assembly to put it on the Uprights. If necessary, remove end caps from
the Uprights. Grasp the assembly near the Uprights and tilt it to move clear of the height
adjustment holes in the Uprights. Carefully slide it down the Uprights.
Note: The scratch guard strips on the front of the Uprights help to protect the finish during
assembly.
NOTICE: Be careful to avoid damage to the plastic sliders inside the E-Z Adjust brackets.
Be sure that the E-Z Adjust Bar assembly fully engages the holes in the Uprights.
Insert the Locking Pins (7a) through the holes in the brackets to lock the E-Z Adjust
Bar in position on the Uprights.
7a
Assembly Steps
7a
10