Sennheiser ew 300 IEM G2 Instructions For Use Manual page 60

Connecting the antenna to the rear
of the transmitter
Antenna front mounting
When mounting only one transmitter into a rack, use the blanking plate
instead of the second transmitter.
To mount only one transmitter
Hook the two rack mount "ears"
Secure the rack mount "ears" to the transmitter using two of the supplied
recessed head screws (M 3x6) respectively.
Secure the blanking plate
of the supplied recessed head screws (M 6x10).
If you are not front mounting the BNC output connector, insert the two
blanking plugs into the holes of the blanking plate.
Slide the transmitter into the 19" rack.
Secure the rack mount "ears" to the rack.
Connecting the antenna
The supplied telescopic antenna can be mounted quickly and easily and are
suitable for all applications where – good transmission conditions provided –
a wireless transmission system is to be used without a large amount of
installation work.
Connect the telescopic antenna to the BNC socket
transmitter.
Pull the end cap to extend the telescopic antenna
Use a remote antenna (available as an accessory) when the transmitter
position is not the best antenna position for optimum transmission.
When mounting only one SR 300 IEM G2 transmitter or one SR 350 IEM G2
twin transmitter into a rack, you can use an antenna mount (optional
accessory) to mount the transmitter's antenna connection to the front of the
rack.
Use the antenna mount matching the respective transmitter:
For the SR 300 IEM G2 transmitter: AM 2 antenna mount
For the SR 350 IEM G2 twin transmitter: GA 3030 AM antenna mount
into a rack:
to the front panel of the transmitter.
to one of the rack mount "ears"
.
using two
at the rear of the
13