Setting And Starting A Washing Programme - Zanussi ZSF2450S User Manual

A
5
Use of detergent tablets
Put the detergent tablet in the detergent dis-
penser (A).
Detergent tablets contain:
• detergent
• rinse aid
• other cleaning agents.
Do these steps to use detergent tablets:
1. Make sure that the detergent tablets are ap-
plicable for your water hardness. Refer to the
instructions from the manufacturer.
2. Set the lowest levels of water hardness and
rinse aid dosage.

Setting and starting a washing programme

Set the washing programme with the door
ajar. The washing programme only starts af-
ter you close the door. Until then it is possible to
modify the settings.
Do these steps to set and start a washing pro-
gramme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press one of the programme buttons. Refer
to the chapter 'Washing programmes'.
– The programme indicator light comes on.
– All other programme indicator lights go
off.
– The digital display shows in flashing the
programme duration.
– The phase indicator light for the washing
programme starts to flash.
4. Close the door.
10
6
It is not necessary to fill the salt container
and the rinse aid dispenser.
Do these steps when the drying results are
not satisfactory:
1. Fill the rinse aid dispenser with rinse aid.
2. Set the rinse aid dosage to position 2.
Do these steps to use the detergent powder
again:
1. Fill the salt container and the rinse aid dis-
penser.
2. Set the water softener to the highest level.
3. Do a washing programme without dishes.
4. Adjust the water softener. Refer to the chap-
ter 'Setting the water softener'.
5. Adjust the rinse aid dosage.
Different brands of detergent dissolve in
different times. Some detergent tablets do
not have the best cleaning results during short
washing programmes. Use long washing pro-
grammes when you use detergent tablets to fully
remove the detergent.
– The washing programme starts automati-
cally.
– The phase indicator light for the washing
programme is on.
When the washing programme operates,
you cannot change the programme. Cancel
the washing programme.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Cancelling a washing programme
1. Press and hold function buttons B and C until
all the programme lights come on.
2. Release function buttons B and C to cancel
the washing programme.
At this time you can do these steps:
1. Switch off the appliance.