Labels - GBC 930-115 Operator's Manual

Operations Manual

1.3 Labels

Safety warning labels are placed at various locations on
the laminator. Do not remove any of these labels. They
are placed for your safety as well as the safety of those
working around you.
Below are illustrations of the safety labels and a description
of their meanings.
Hot rollers
– The safety labels below mean that you could be burned
and your fingers and hands could be trapped and crushed
in the rollers. Jewelry and long hair could be caught in the
rollers and you could be pulled into them.
One of each label is placed on each side from the front
operating position just in front of the heat rollers nip.
Electrical hazard
– The safety label below means that you could be seriously
hurt or killed if you open the product and expose yourself
to hazardous voltage.
© 2004 General Binding Corporation
This label is located on the rear panel in the center of the
laminator just below the film supply shaft between the pull
rollers and decurling bar.
- The safety label below means that you should always
replace a fuse with the same size and type of fuse. This
will reduce the risk of fire.
This label is located on the side cover near the fuse panel
located on the rear of the machine.
Pinch point
– The safety label below means use extreme caution when
placing your hands in the proximity of the pull rollers nip.
You should never place your fingers or other items in this
area while the machine is running.
This label is located between the pull rollers and the
decurling bar center of the rollers.
Polaris II
Page 1-3