Gateway MAN FX510 Reference Manual page 118

4
5
6
7
8
9
112
CHAPTER 6: Troubleshooting
Insert a blank, recordable disc into a recordable disc
drive, then click Next. If an AutoPlay dialog box opens,
click the x in the upper-right corner to close it.
A dialog box opens that tells you the number of blank
discs you will need to create a full set of recovery discs.
If you have enough blank discs of the specified type,
click I have enough discs, then click Next. If you do
not have enough discs, choose a different disc type, or
click Cancel.
The disc recording begins. Label the discs as they are
completed.
Important
Use a permanent marker to label each disc "Software and Driver
Recovery," along with a short description of which computer the discs
are for. If you are recording multiple discs, as you remove each disc
from the drive, use the marker to label each disc 1 of x, 2 of x, 3 of
x, and so on.
Tip
After a recovery disc is created, your computer names the disc
Recovery13 for disc 1 of a 3-disc set, Recovery23 for disc 2, and
so on.
If multiple discs are required, insert the additional blank
disks when prompted.
When the process is finished, the Congratulations!
window opens.
Click Finish.
Remove your final disc, then label all of the discs and
store them in a safe place.