Advertisement
Addendum: Owner's Guide
The VSS4000 integrates the Viper 5101 Remote Start with the VSM100 Viper SmartStart Module. Read this addendum
and both installation guides thoroughly before beginning. They will help you understand how to combine the two
systems, avoid mistakes, and smoothly complete the installation, verification and customer registration processes.
The corrections made in this addendum address the 5101 Owner's guide (G4102V 2008-06) as it pertains to the
VSN4000 kit.
Owner's guide
Page
Description/error
9
What's included:
This list has changed to integrate
two systems, see Correction column.
10
"Battery replacement" procedure is
incorrect.
11
Item 7 reference to battery door is
incorrect.
13
Unlock section title at top of page is
incorrect.
Aux/Trunk command instruction
"Press one time" is incorrect.
16
Unlocking the Vehicle begins:
Lock the vehicle normally. Press.....
All
References to "beeps" on most
pages of the guide are incorrect.
Battery Replacement
1.
Using a small slotted screwdriver or similar tool, insert into unit slot and gradually pry the top away from the
bottom until free.
2.
Remove the top along with the circuit board and turn both upside down. Remove battery from battery clip and
replace.
Note: Verify polarity while replacing the battery as the battery clip will also accept the battery if incorrectly
inserted upside down.
3.
With the unit top and circuit board still upside down. Turn unit bottom over and onto the other two parts. Snap
unit back together.
2
! ATTENTION OWNER !
Correction
The VSS4000 system includes:
VSM100 Viper SmartStart module, wire harness, Quick
reference User's & Installation guide. Module ID stickers.
5101V remote start/keyless entry main module, Owner's
guide and this addendum
Control Center with integrated Valet Override switch
One five button/1way Supercode remote control
Window decals
Warranty registration cards
See "Battery Replacement" procedure below.
There is no battery door on the 7153V remote control.
Top section title next to closed lock icon should be "Lock".
Should be "Press and Hold for 1 1/2 seconds".
Should read:
To Unlock the vehicle. Press.....
Beep generator has been removed from the 7153V remote
control, references to LED blinks are correct.
© 2009 Directed Electronics. All rights reserved.
Advertisement
