Viper VSS4000 Installation Manual

Addendum: Installation Guide
The VSS4000 integrates the Viper 5101 Remote Start with the VSM100 Viper SmartStart Module. Read this addendum
and both installation guides thoroughly before beginning. They will help you understand how to combine the two
systems, avoid mistakes, and smoothly complete the installation, verification and customer registration processes.
The corrections made in this addendum address the 5101 installation guide (N4102V 2008-06) as it pertains to the
VSN4000 kit.
Installation guide
Page # Description/error
Inside front Error is found in the Bitwriter® chip ver-
cover & 31 sion requirement: version 2.5
7 What is included:
This list has changed to integrate two
systems, see Correction column.
36 Step 1 reads:
Hold....until you hear it emit a long
beep. The transmit LED comes on solid.
56 Remote starting diagnostics correction to
introduction paragraph
! ATTENTION INSTALLER !
Correction
The Bitwriter (p/n 998U) requires chip version 2.6
or newer to program this unit.
The VSS4000 system includes:
One - 5101V remote start/keyless entry main
module, Owner's & Installation guide, QR Wiring
guide, (and supporting documentation).
One - five-button /1-way Supercode remote con-
trol (p/n 7153V)
One - Control Center with integrated Valet Over-
ride switch
One - Shutdown toggle switch
One - VSM100 Viper SmartStart module, wire
harness, Quick reference User's & Installation
guide. Module ID stickers.
Should read:
1. Hold the
transmit LED lights solid (approx. 10 seconds).
2. Press and hold the
blinks three times and then lights solid.
Should be:
A few select system conditions may prevent the en-
gine from starting. The condition that causes this
non-start will be reported by flashing the vehicle
parking lights. The number of flashes and the list
below identify the condition.
A U X
button on the remote until the
button until the LED
A U X
ADVSS4000 2009-09