Netvanta 6330 Series Front Panel Design; Netvanta 6330 Rear Panel Design; Figure 3. Netvanta 6330 Series Front Panel Layout; Figure 4. Netvanta 6330 Series Rear Panel Layout - ADTRAN 6310 Installation Manual

Physical Description

NetVanta 6330 Series Front Panel Design

The NetVanta 6330 front panel is shown below.
NetVanta 6330 Front Panel Features
Status LEDs
The status LEDs are located on the lower left side of the unit. The
status. The FXO LED reflects the status of the FXO interfaces. The
FXS interfaces. The
(located on the rear panel). The
SLOT 1
networks (LANs).
CompactFlash Slot
The CompactFlash slot supplies nonvolatile configuration and compressed code storage. CompactFlash
densities from 64 to 1024 MB are supported.
LAN 1
STATUS FXS
LAN 2
FXO SLOT 1

NetVanta 6330 Rear Panel Design

The NetVanta 6330 rear panel is shown below.
VOICE
NetVanta 6330 Rear Panel Interfaces
VOICE Connector
A single 50-pin female amphenol connector labeled
24 analog ports. See
NIM2/VIM2 Option Slot
The NIM2/VIM2 option slot (labeled
to Option Modules on page
FXO Ports
The two FXO interfaces (labeled
44 for the FXO connector pinouts.
18
Table 1 on page 19
LED reflects the status of a NIM2/VIM2 installed in NIM2/VIM2 option
SLOT 1
LAN 1

Figure 3. NetVanta 6330 Series Front Panel Layout

SLOT 1

Figure 4. NetVanta 6330 Series Rear Panel Layout

Table A-5 on page 44 for the
SLOT 1
23).
and
FXO 0/1
Copyright © 2013 ADTRAN, Inc.
NetVanta 6310/6330 Series Hardware Installation Guide
describes all of the LEDs.
STAT
FXS
and LEDs reflect the status of the local area
LAN 2
FXO
0/1 0/2
provides the interconnect wiring for up to
VOICE
connector pinouts.
VOICE
) accepts a variety of NIM2/VIM2 option modules (refer
) provide FXO connectivity. See
0/2
LED indicates the unit's
LED reflects the status of the
NetVanta 6330
CompactFlash
100-240 VAC
ETH 0/1
50/60 Hz
ETH 0/2
Table A-4 on page
61700100G1-34F