Listening To Fm Radio - iHome iHM28 Operation Instruction Manual

At the set time, the alarm will sound for 1 hour. If waking to Aux-in, make sure your device is connected to the aux-in audio cable
and has an hour of music in it or is set to repeat.
1. To turn off the sounding alarm and reset it to come on at the same time the following day, press and release the
The alarm sound will stop but the alarm icon will remain in the display, indicating the alarm is armed. To turn off
the alarm without resetting it for the next day, press and release the Alarm Button.
2. Press and release the Alarm Button during normal operation (alarm is not sounding) as needed to arm the alarm (alarm
icon is present) or to cancel it (no alarm icon).
3. Press and release the Snooze Button while alarm is sounding to temporarily silence the alarm for the set snooze time
(default is 9 minutes). To adjust the snooze time: press and hold the Snooze Button during normal operation. The
snooze time will flash on the display and 1 beep sounds.
minutes. Press and release the
snooze setting and return unit to normal operation.
Setting up the Antenna
Extend the FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the Radio
1. Press and release the radio/aux Button as needed to cycle through FM radio and Aux-in modes.
2. When FM mode is selected, press
appears in the lower part of the display. Press and hold
station.
3. To memorize a station as a preset:
A. Press the presets
and then hold the presets
sounds.
B. Press the + or – Button to tune the radio to a desired station. Hold briefly to have the radio autoscan/search for the
next clear station.
C. Press the presets
number you wish to assign. Repeat steps A-C to preset up to 6 stations.
4. To listen to a preset station, press the presets
5. Press the or Button on the unit to adjust the system volume.
Operating the Alarm
Snooze Button
again (or no button within 10 seconds). Two beeps will sound to confirm

Listening to FM Radio

the + or – Button to tune the radio to a desired station. The current radio frequency
Button as needed to step through the 6 presets (P1 - P6) to the number you wish to assign,
Button until the selected preset number begins flashing in the display and 1 beep
Button to confirm the setting, two confirmation beeps will confirm the setting and the preset
Press the – or + Button to adjust the snooze time from 1 - 29
the + or – Button for a few seconds to scan for the next clear
Button to choose the desired preset.
5
Button.