Using Coaxial (Good) - Insignia NS-32D201NA14 User Manual

Using coaxial (good)

On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
To connect a cable or satellite box using coaxial:
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the coaxial out
jack on the cable or satellite box.
4 Plug your TV's power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the INPUT SOURCE list.
6 Press or to highlight TV, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See
page 47.
Notes
• Use a coaxial cable to eliminate interference and noise from radio
• Do not bundle the coaxial cable with the power cord or other cables.
17
waves.
www.insigniaproducts.com
NS-32D201NA14 Insignia 32" LED TV
Back of TV
Coaxial cable
"Automatically scanning for
Cable or
satellite box
channels" on