Samsung RF32FMQDBSR/AA, RF32FMQDBSR/AA-0000 User Manual page 14

HOW TO ADJUST THE DOOR GAP
if the gap between the left and right fridge
compartment doors is not even,
• You can adjust the gap by turning
the bolt at the top right of the cold
storage compartment door.
• Do not turn the bolt too far,
You can break it,
1. With the doors closed, remove the 3 screws
holding the top cover using a Phillips
screwdriver, and then lift it off together with the
connected cables,
2. Turn the bolt with a 4 mm ' _ ......
hexagonal L-wrench to adju st _ -__
the gap, (Not provided) _ --5_-_
/
3. Turn the bolt clockwise to _/_//i=--_--
(_,,._) widen the gap.
Turn the bolt counter clockwise (,,..._) to narrow
the gap,
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that,
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138-862 kPa) is required,
if the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure,
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet,
• Water line installation kits are available at
extra cost from '_our dealer.
We recommend using a water line
installation kit that contains copper
tubing and 1A" compression nut,
Connecting to the water supply line
1. First, shut off the main water
supply,
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve,
Cold water line--
3. Connect the water line installation kit to the shut
off valve,
Pipe clamp --
Water line installation kit
Connecting the water supply line to the
refrigerator.
There are several items that you need to purchase
to complete this connection,
You may find these items sold as a kit at your local
hardware store,
For Copper Tubing For Plastic Tubing
,,, 1A"copper tubing ', IA" plastic tubing
• 1/4"compression nut (1 pc) _ Molded end(Bulb)
Ferrule (2pc) ® 1/4"compression nut (1pc)
14 setting up