Location
of the radiant surface elements
and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
1, Single element:
Left rear
2. Single element:
Right rear
3, Dual element:
Left front
4, Triple element:
Right front
5, Warming center: Center rear
6. Hot surface indicator
Hot surface indicator
•
Comes on when the unit is turned on or hot to the touch.
•
Stays on even after the unit is turned off.
•
Glows until the unit is cooled to approximately 150°R
Cooking
areas
•
The cooking areas on your range are identified by permanent circles on the glass cooking
surface. For the most efficient cooking, fit the pan size to the element size.
•
Pans should not extend more than 1/2" to 1" beyond the cooking area,
= When a control is turned on, a glow can be seen through the glass cooking surface. The
element
will cycle on and off to maintain the preset heat setting, even at high settings,
= For more information on selecting proper types of cookware, refer to the section "Using the
proper cookware" on page 23.
19 Surface cooking
NE597ROABSR
AA
DG68-O0431A-03_EN.indd
19
2013-05-23
[_ 5:29:22