Advertisement
o
o
From the JP Settings
screen,
set JP Setting
to Enter manually,
enter JP Address,
Subnet
Mask,
Gateway,
and the DNS Server
values,
and then select OK.
Use one of the two methods
below
to enter the numerical
values.
Use the on-screen
QWERTY keypad.
Press the _7_s_!_qo
_
_ and use the keys on the number
panel.
The TV attempts
to connect
to the network
again using the specified
settings.
A confirmation
message
is then shown
once a connection
is established.
Select OK to proceed.
Faimed Wired Connection
No
network
cable
found
....
.... q'iiiii&_i@@HiiilhlilHii,i@i_iii_@iii_
"qiiii&_i@@HiiilhlilHii'i@i_i_ii_@iii
_
Make sure the network
cable is plugged
in. If it is connected,
make sure the router is turned
on. If it is
on, try turning
if off and on again.
_P auto
settin
9 fai_ed
}:/_
Perform
the following
or set the IP address
manually
from JP Settings.
Ensure that the DHCP server is enabled
on the router and reset the router.
2,
If this does not work, contact
your
Internet
Service
Provider
for more information.
UnaMe
to connect
to the network
Check the following:
Check the JP Settings
settings.
2,
Ensure that the DHCP server is enabled
on the router and unplug
and then plug the router back in.
3,
If this does not work, contact
your
Internet
Service
Provider
for more information.
Advertisement
