Sony DWZB70HL Operating Instructions Manual page 2

Digital wireless package
Hide thumbs Also See for DWZB70HL:
Table of Contents

Advertisement

For the ZTX-M02RC/B02RC
Transmitters
Owner's Record
The model and serial numbers are located at the rear or on
the bottom of the unit. Record the model and serial
numbers in the space provided below.
Refer to these numbers whenever you call upon your
Sony dealer regarding this product.
Model No. _____________________
Serial No. ______________________
WARNING
Batteries shall not be exposed to excessive heat such as sunshine,
fire or the like.
If the transmitter develops an abnormally high temperature, a
burning odor or smoke during use, remove the battery holder and
stop using the transmitter immediately.
Take care not to burn your fingers when removing the battery
holder as the batteries may be very hot at this time.
For the customers in the U.S.A.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
All interface cables used to connect peripherals must be shielded in
order to comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
If you have any questions about this product, you may call ;
Sony Customer Information Service Center 1-800-222-7669 or
http://www.sony.com/
Declaration of Conformity
Trade Name : SONY
Model : ZTX-M02RC/B02RC
Responsible party : Sony Electronics Inc.
Address : 16530 Via Esprillo, San Diego, CA 92127 U.S.A.
Telephone Number : 858-942-2230
This device complies with part 15 and part 18 of the FCC
Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE: To comply with the FCC RF exposure
compliance requirements, no change to the antenna or the device is
permitted.
2
Any change to the antenna or the device could result in the device
exceeding the RF exposure requirements and void user's authority
to operate this device.
This device complies with FCC radiation exposure limits set forth
for uncontrolled equipment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65. This device
has very low levels of RF energy that it is deemed to comply
without testing of specific absorption ratio (SAR).
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
For the customers in Canada
This Class B digital apparatus complies with Canadian ICES-003.
This ISM device complies with Canadian ICES-001.
This device complies with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device.
The term "IC:" before the radio certification number only signifies
that Industry Canada technical specifications were met.
This equipment complies with IC radiation exposure limits set forth
for an uncontrolled environment and meets RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very low levels
of RF energy that are deemed to comply without testing of specific
absorption ratio (SAR).
For the customers in Europe
Hereby, Sony Corporation, declares that this ZTX-M02RC/B02RC
is in compliance with the essential requirements and other relevant
provisions of the Directive 1999/5/EC.
For details, please access the following URL: http://
www.compliance.sony.de/
Voor de klanten in Europa
Hierbij verklaart Sony Corporation dat het toestel ZTX-M02RC/
B02RC in overeenstemming is met de essentiële eisen en de andere
relevante bepalingen van richtlijn 1999/5/EG.
Nadere informatie kunt u vinden op:
http://www.compliance.sony.de/
För kunder i Europa
Härmed intygar Sony Corporation att denna ZTX-M02RC/B02RC
står I överensstämmelse med de väsentliga egenskapskrav och
övriga relevanta bestämmelser som framgår av direktiv 1999/5/EG.
För ytterligare information gå in på följande hemsida: http://
www.compliance.sony.de/
Para clientes na Europa
Sony Corporation declara que este ZTX-M02RC/B02RC está
conforme com os requisitos essenciais e outras disposições da
Directiva 1999/5/CE.
Para mais informacoes, por favor consulte a seguinte URL:
http://www.compliance.sony.de/
Til europæiske kunder
Undertegnede Sony Corporation erklærer herved, at følgende
udstyr ZTX-M02RC/B02RC overholder de væsentlige krav og
øvrige relevante krav i direktiv 1999/5/EF.
For yderligere information gå ind på følgende hjemmeside:
http://www.compliance.sony.de/

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dwzm70

Table of Contents