Sony DWZB70HL Operating Instructions Manual page 16

2
Specify the channel using one of the following
methods.
Note
When configuring settings using method A or B, turn
off all transmitters beforehand.
ASelect [Best Channel Selection]
The channel with the least interference will be
configured automatically.
BSelect [Clear Channel Scan]
The status of all the channels in the selected RF
mode will be displayed, allowing you to select the
channel you want to use.
If there are no open channels, "No Clear Channel"
appears.
Display
White font
(underlined)
White font
Gray font
"No Clear Channel" No usable channels available.
CSelect [Manual Setup]
Configure the channel manually. Select the
channel you want to use.
This completes the configuration, and the main
screen appears again.
Caution
If you change the channel setting, be sure to change the
channel setting on the transmitter to the same channel. If
the receiver channel and transmitter channel are not
identical, audio will not be output.
Configuring the effect level
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [Feedback Reducer].
The [Feedback Reducer] screen appears.
3
Select [Effect Level].
The [Effect Level] screen appears.
16
Receiver Settings
Status
Channel with low interference.
Channel with relatively low
interference.
Channel with high
interference, or channel that is
being used by another device.
4
Select the effect level you want to use.
5
Select [Set].
This completes the configuration, and the main
screen appears again.
Configuring the feedback reducer
function for connectors
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [Feedback Reducer].
The [Feedback Reducer] screen appears.
3
Select [Apply Feedback Reducer].
The [Apply Feedback Reducer] screen appears.
4
Select the connectors for which you want the
feedback reducer function enabled.
Screen display
Connector
BALANCED OUTPUT
UNBALANCED
OUTPUT MAIN
UNBALANCED
OUTPUT AUX/
TUNER
This completes the configuration, and the main
screen appears again.
Configuring the equalizer
1
In the [Setup] screen, select [Audio Setup].
The [Audio Setup] screen appears.
2
Select [Equalizer].
The [Equalizer] screen appears.
3
Select [On] to enable the equalizer function, or [Off]
to disable it.
If you select [On], the equalizer settings screen
appears.
If you select [Off], configuration is complete and the
main screen appears again.
To All To To
Balanced
Outputs AUX/
& Main
Tuner
Only
Only
–
Enabled
–
Enabled
– Enabled