Setting The Encrypted Transmission Function (Encryption); Generating An Internal Signal (Internal Sg); Locking The Power Switch (Power Sw Lock); Cross Remote (Rf Remote) - Sony DWTB01/E1424 Operating Instructions Manual

Setting the encrypted
transmission function
(ENCRYPTION)
You can set the encrypted transmission
function.
SECURE KEY: Sets the secure key
method.
PASSWORD: Sets the password method.
OFF: The encrypted transmission function
is not used.
For details, see "Using the Encrypted Transmission
Function" on page 14.
Generating an internal
signal
(INTERNAL SG)
This transmitter generates a 1-kHz
reference level sine wave that can be used to
adjust or check the audio level of the
receiver or the system that you are using.
This internal signal is outside the control of
the attenuator.
1 kHz: A 1-kHz internal signal is
generated.
OFF: An internal signal is not generated.
Note
If the transmitter is turned off while the
reference signal function is on, the function
will turn off automatically.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 12.
Locking the POWER switch
(POWER SW LOCK)
The POWER switch can be locked to
prevent the transmitter from being
accidentally turned off or on.
Even when the POWER switch is locked,
all parts of the transmitter other than the
POWER switch remain functional.
UNLOCK: The POWER switch is not
locked.
LOCK: The POWER switch is locked.
When LOCK is selected, the POWER
switch lock icon appears in the display.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 12.
Cross Remote
This function must be set to allow the
wireless remote control function to be used
between the transmitter and receiver.
OFF: Stops the wireless remote control
function.
ON: Starts the wireless remote control
function with the previously paired
receiver.
PAIRING: Executes a new pairing.
For details, see "Pairing with a receiver" on
page 12.
Note
If "RESTRICTED BY GP/CH SETTING"
appears on the RF REMOTE screen, the
wireless remote control function cannot be
used. To use the wireless remote control
function, select a different transmission
channel.
(RF REMOTE)
Setting Menus 21