Selecting The Group/Channel - Sony DWTB01/E1424 Operating Instructions Manual

Selecting the group/
channel
Notes
• Before doing this procedure, use the
BAND function (see page 18) to set the
transmitter to the bandwidth of the
receiver you are using.
• The setting for this function cannot be
changed during actual signal
transmission.
Set the transmitter group (GP) and channel
(CH) as follows:
For details on groups and channels, refer to "Sony
Digital Wireless Microphone System Frequency
Lists" on the supplied CD-ROM.
For details on menu operation, see "Basic Menu
Operations" on page 17.
1
Turn off the power, and then while
holding down the SET button, turn the
power on.
The signal transmission stops.
2
Press the + or – button repeatedly until
the GP/CH indication is displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or – button repeatedly to
select a group.
5
Press the SET button to enter the
group.
The channel indication starts flashing.
6
Press the + or – button repeatedly to
select a channel.
7
Press the SET button to enter the
channel.
Note
To start signal transmission with the
selected channel, turn off the power and
then turn it on again.
To set the group/channel
using the pairing mode of the
Cross Remote
When the transmitter is paired with the
receiver, the transmission channel of the
transmitter is set to the receiving channel on
the receiver automatically.
For details, see"Pairing with a receiver" on
page 12.
Setting the Transmission Channel 11