Husqvarna LTH2038R Operator's Manual page 11

The operation of any tractor can result in foreign objects thrown into the eyes, which can result
in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor
or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide
vision safety mask worn over spectacles.
HOW TO USE YOUR TRAC TOR
TO SET PARKING BRAKE (See Fig. 7)
Your tractor is equipped with an operator presence sens-
ing switch. When engine is running, any attempt by the
op er a tor to leave the seat without first setting the parking
brake will shut off the engine.
• Depress brake pedal (B) all the way down and hold.
• Pull parking brake lever (C) up and hold, re lease pres-
sure from brake pedal (B), then release parking brake
lever. Pedal should re main in brake position. Make
sure parking brake will hold tractor secure.
B
STOPPING (See Fig. 8)
MOWER BLADES -
• To stop mower blades, place attachment clutch control
in the "DIS EN GAGED" position (
( ) ATTACHMENT
CLUTCH CONTROL
"DIS EN GAGED"
GROUND DRIVE -
• To stop ground drive, depress brake pedal into full
"BRAKE" position.
IMPORTANT: FORWARD AND REVERSE DRIVE PEDALS
RETURN TO NEUTRAL POSITION WHEN NOT DEPRESSED.
ENGINE -
• Move throttle control (D) to fast position.
NOTE: Failure to move throttle control to fast position,
before stop ping may cause engine to "backfire".
OPERATION
Fig. 7
).
( ) ATTACHMENT
CLUTCH CONTROL
"ENGAGED"
Fig. 8
• Turn ignition key (F) to "
Always remove key when leaving tractor to prevent
un author ized use.
• Never use the choke to stop the engine.
IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY
POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY
TO DISCHARGE AND GO DEAD.
NOTE: Under certain conditions when tractor is standing
idle with the engine running, hot en gine exhaust gases
may cause "browning" of grass. To eliminate this possibility,
al ways stop engine when stopping tractor on grass areas.
C
TO USE THROTTLE CONTROL (D) (See Fig. 9)
Always operate engine at full speed (fast).
• Operating engine at less than full speed (fast) reduces
engines operating efficiency.
• Full speed (fast) of fers the best bagging and mower
per for mance.
TO MOVE FORWARD AND BACKWARD
(See Fig.10)
The direction and speed of movement is controlled by the
forward and reverse drive pedals.
• Start tractor and release parking brake.
• Slowly depress forward (K) or reverse (L) drive pedal to
begin movement. Ground speed increases the further
down the pedal is depressed.
11
" position and remove key.
STOP
CAUTION: Always stop tractor com-
plete ly, as described above, and set
parking brake before leav ing the op er a-
tor's position.
D
F
Fig. 9
K
L
Fig. 10