Cabinetry
Cutout for 27" (68.6 c_)Single or
Double
uilt-ln Ovens only-Over
a
arming Drawer
For JKSI0,
JKP30, JKP35, JKP55, JKP70, JKP75, PK916, PK956, ZEK938,
ZEK958 models
only.
Single 27" (68.6 cm)
Oven Over
a Warming Drawer
Double 27" (68.6 cm)
Oven Over
a Warming Drawer
Per
Warming
Drawer
Requirement
J
Anti-Tip B!ock Against
Rear Wall Per Warming
Drawer Requirement
2" (S.1 cm)
Min.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
1" (2.5 cm) Min. Above Toekick or
Adjust
to Oven Installation
Height
NOTE: Additional
clearances
between
cutouts
may be required.
Check to be sure the oven
supports
above the Warming
Drawer location
do not obstruct
the required interior depth and
height.
Anti-Tip
Block
Against
Rear
•Wall Per
Warming
Drawer
Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Reql
1" (2.5 cm) Min. Above Toekick
• When installing
a Warming
Drawer below
a single or double oven, a separate
120V,
60 Hz, properly grounded
receptacle
must
be installed.
Refer to installation
instructions
packed with the Warming
Drawer for
specific
installation
requirements.
7