Cabinetry
Cutout for
30"(76.2cm)
Single or Double
Built-In Ovens only-
Over a
Warming Drawer
For JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960,
ZET938, ZET958 models only.
Single 30" (76.2 cm)
Oven Over a Warming
Drawer
Double 30" (76.2 cm)
Oven Over a Warming
Drawer
Per Warming
Drawer
Requirement
Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
NOTE: install the
oven only with
specific models
Iisted on the labeI
located on top of
the oven.
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
NOTE:
Additional
clearances
between
cutouts
may be required.
Check to be sure the oven
supports
above the Warming
Drawer location
do not obstruct
the required interior depth and
height.
Anti-Tip Block
Against Rear
Wall Per
Warming
Drawer
Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
1" (2,5 cm) Min. Above Toekick
° When installing
a Warming
Drawer below
a single or double oven, a separate
120V,
60 Hz, properly grounded
receptacle
must
be installed.
Refer to installation
instructions
packed with the Warming
Drawer for
specific
installation
requirements.
12